|
이---름 : |
관리자
|
조---회 : |
16416 |
|
| 글쓴날짜 : 2006-02-07 |
안녕하십니까?
ASTM D1000은 현재 폐기된 규격입니다만 내용 요약은 다음과 같습니다(영어로 소개하여 죄송합니다)
1. ASTM D1000
D1000-99 Standard Test Method for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications
1.1 These test methods cover procedures for testing pressure-sensitive adhesive-coated tapes to be used as electrical insulation and are classified as follows:
1.1.1 Class 1 -Non-elastomeric backings made FROM materials such as: Paper, flat or creped, Fabric, uncoated or coated, Cellulose ester films, Polyethylene terephthalate (polyester) films, Fluorocarbon polymer films, Composite filament films, Polyamide films, Polyimide films, and Combinations thereof.
1.1.2 Class 2 -Elastomeric backings that are characterized by both high stretch and substantial recovery made FROM materials such as: Vinyl chloride and co-polymers, Vinylidene chloride and co-polymers, and Polyethylene and co-polymers.
Note 1-Laminates of Class 1 and Class 2 backings should be tested according to Class 1 test methods.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards see Section 3.
1.3 The procedures appear in the sections indicated:
Paper, flat or creped, Fabric, uncoated or coated, Cellulose ester films, Polyethylene terephthalate (polyester) films, Fluorocarbon polymer films, Composite filament films, Polyamide films, Polyimide films, and Combinations thereof.
2. ASTM D3330은 다음과 같습니다.
D3330-04 Standard Test Method for Peel Adhesion of Pressure-Sensitive Tape
2.1 These test methods cover the measurement of the peel adhesion of pressure-sensitive tapes.
2.1.1 Test Method A gives a measure of the adherence, when peeled at 180 angle, to a standard steel panel or to other surface of interest for a single-coated tape.
2.1.2 Test Method B gives a measure of the adherence to the backing of a single-coated tape.
2.1.3 Test Method C gives a measure of the adherence of double-coated tape to a standard steel panel or other surface of interest.
2.1.4 Test Method D gives a measure of the adherence of the release liner to the adhesive of either single- or double-coated tape.
2.1.5 Test Method E gives a measure of the adherence of an adhesive transfer tape to a standard steel panel or other surface of interest.
2.1.6 Test Method F gives a measure of the adherence, when peeled at 90 angle, to a standard steel panel or other surface of interest for a single-coated tape.
2.2 These test methods provide a means of assessing the uniformity of the adhesion of a given type of pressure-sensitive adhesive tape. The assessment may be within a roll of tape, between rolls, or between production lots.
감사합니다
>ASTM1000과3330D의 내용이 넘 궁금하네요?
|
|
|
|
HOME > 커뮤니티 > Q&A
ASTM D1000과 D3330 
